Roof Anchor Installation Instructions

Screw the new panel in place as described.

Roof anchor installation instructions.

Roof anchors installed for restraint applications must be attached to a roof member capable of sustaining a static load of at least 3 000 lbs. Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling. Metal roofing is also available in the form of shingles. More than one roof anchor is installed to a roof structure the strengths given in a or b above must be met at each roof anchors installation point independently.

If two roof anchors are installed onto a roof structure each anchor location must be independently capable of supporting 5 000 lbs. Continue adding panels until the roof is covered. During installation and assembly of the anchor device ensure that the installer is not less that 2 m from any edge or opening. 3 0 operation and use.

The roof material must be capable of supporting a minimum tensile load of 5 000 lbs. Lay flat cap nail flat. Reliable roofing is a professional commercial roofing contractor that can provide roof anchor installation services in lake zurich il and the north chicago suburbs. Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system.

Each roof anchor installation must be independently capable of sustaining this load. Not for use as an abseiling point. Both permanent and temporary roof anchor points are available. If the material is not able to support 5 000 lbs.

Minimum tensile load a qualified person must confirm that the support structure maintains a safety factor of two as per osha 1926 502. 2 way roof anchor installation instructions this product is part of a personal fall arrest system. Each of our roofing technicians has received extensive training to properly install roof anchors within the rules and regulations of osha. Install the panel so that the short lip overlaps the large lip.

In general roof anchors should be installed on roofs or structures that are made of wood and sheathing. Do not stretch during installation. Installation guidelines for different slopes categories are listed below. Always install the anchor device so no part of the device is less 2 5 m from the edge of the roof or opening.

Slopes 4 12 and more a lay out anchordeck synthetic roofing underlayment horizontally parallel to the eave with the printed side up. You may need to cut panels to fit angles using a circular saw with a metal saw blade. Installation of this roof anchor must be certified by a qualified person or engineering service. B install anchordeck synthetic roofing underlayment without wrinkles.